- ページ 12

コントローラー Astrolite WARRIOR 360のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Astrolite WARRIOR 360 13 ページ。

The channels that have been assigned to the function wheels will automatically with slope when the chase is running.

Other channels can also be set up with slope, too.

Step

Press Program to enter programming mode

Press SlopeSet.

Select the desired fixture.

Push the channels that you want to set up with slope till the LED indicators of the sliders

are on. Press Release , and then push the slider, to release the selected channels.

Press SlopeSet again. Then, the setup is finished. Slope will be with the channels when

chase is running.

Example:

To set Channel 5 & 6 of Fixture 1 with slope:

Press Program -> SlopeSet -> Select Fixture 1 -> Push the sliders of CH5 & CH6 till the LED indicators are

on -> SlopeSet. OK.

XIV. Delete

Step

Press Del

Select what you want to delete from SC1, SC2, SC3, Chase1, Chase2, Group, <=/SETX

or SlopeSet

Select the number buttons from 1—18 for delete. (<=/SETX, =>/SETY and SlopeSet do

not need to press number button).

Deleted.

Note:

Example: To delete the chase in number button 2 of Chase 1

Press Del-> Chase1-> 2 , OK.

XV. Troubleshooting

Fixture does not response to the controller: Check the address code of the fixture and in the controller.

Make sure they are the same. And, make sure the connections are correct.

Interference between chases: If a same channel is in different simultaneously running chases, the one with the

maximum channel value will be output.

Note: When in programming mode, as long as the LED indicator is on, the value will be stored, even the value

is zero.

Except for the channels assigned to the function wheels and the channels set with slope, slope is not with other

channels.

Description