ページを印刷するLevels
The amplifier section can deliver up to 0.5W RMS per channel and has a fixed gain of
20dB. The volume potentiometer varies the input level to the amplifier stage. Too
high an input level here will reduce the useful control over the output volume, since it
will have to be set very low to ensure that the output does not clip. To adjust this level
see below - 2 & 8 Inputs.
Note on the problems of Loudness and Headphones
Our amplifier cannot do the impossible! We can only make headphones as loud
as they are capable of being. Beyond that they distort and clip, which is very bad
for your ears, short and long term. The problem usually is not so much that the
headphones are not loud enough; it is more that the sounds outside are too loud
and are breaking through into your ears. Approached from this direction the
problem can perhaps be solved more easily.
Noise floor:
Dynamic range:
THD+N 20Hz to 22kHz, +10dBu into 600R
Frequency response:
Slew rate:
Settling time to 0.1%: this will depend on the load to a great extent,but very good
Max phase rotation (inter channel phase difference):
Crosstalk:
Power output
This unit complies with the following standard (see Declaration of Conformity):
Radiated Emissions to Specification EN50081-1
Conducted Emissions to Specification EN50081-1
Electro Static Discharge to Specification EN50082-1
Fast Burst Transients to Specification EN50082-1
DACS LTD, Stonehills, Shields Road, PELAW, Gateshead, Tyne and Wear NE10 0HW
Tel: +44 (0) 191 4382500 | Fax: +44 (0) 191 4382511 | www.dacs-audio.com | [email protected]
Specifications for DACS' Clarity HEADLITE 3
Compliance to European Standards
<-90dBu (110dB below peak)
>114dB
<.00045%
5Hz to 40kHz ± .5dB
Greater than required for 40kHz
100Hz .01 deg, 1kHz .03 deg,
10kHz .36 deg, 20kHz .72 deg
<-90dB
>200mW/ch into 600R