- ページ 4

フロアマシン Advance acoustic ALL CLEANER XPのPDF 使用説明書およびパーツリストをオンラインで閲覧またはダウンロードできます。Advance acoustic ALL CLEANER XP 13 ページ。 Models: 56380772, 56381594

KNOW YOUR MACHINE DESCRIPTIONS

Operator Handle (1): Operator holds onto this handle to move the machine from one location to another.

Solution Tank Lid (2): This lid screws off so the tank can be ﬁ lled. The solution ﬁ ll hose is tethered to the lid, and hangs inside the arm

of the Operator Handle.

Recovery Tank Lid (3): This lid covers the opening in the Recovery Tank. This is where the operator can access the tank to clean

it and the ball ﬂ oat cage. The tank can be ﬂ ushed out by running clean warm water into this opening and laying the open drain

hose into a bucket or drain.

Recovery Hose (4): Waste water is picked-up through this hose.

Spray Hose (5): This hose delivers water from the machine to the cleaning tool.

Drain Hose (6): This hose is used to empty the recovery tank. NOTE: hold the end of the hose above the water level in the tank

to avoid sudden, uncontrolled ﬂ ow of waste water when you remove the cap, then lower the hose slowly to control the rate of

discharge.

Quick Disconnect (7): Point of attachment for the Spray Hose (5).

Tools & Accessories (8): Various accessories can be stored on the machine.

Castors and Wheels (9): Castors pivot for ease of steering, and large back wheels make it easy to roll the machine from location

to location.

Recovery Hose Inlet (10): Point of attachment for the Recovery Hose (4).

Chemical Feed Lines (11): These clear tubes connect the cleaning chemical containers to the machine where the chemical can

be siphoned into the outlet water from the pump. Metering tips -- used to change the ratio of water to chemical -- are installed

here.

Switch Plate (12): The machine's on/off switches for the vacuum and for the pump are located here and this is where the valve to

change chemical feeds is located.

Power Cord (13): The 25 ft. power cord connects to a power cord pigtail on the rear of the machine.

Chemical Container Holders (14): Two molded-in bottle holders for chemical jugs.

4 - FORM NO. 56380890