- ページ 14
水ポンプ Cole Parmer AIR ADMIRAL 79202-30のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Cole Parmer AIR ADMIRAL 79202-30 20 ページ。 Vacuum/pressure pump (station)
Cole Parmer AIR ADMIRAL 79202-30 にも： オーナーズマニュアル (10 ページ)
ページを印刷する
3.20 LEAK DETECTION
3.21
The importance of eliminating all leaks in a vacuum system
is obvious. The pump must remove this added volume of
leaked gas to maintain the desired vacuum. Leaks for
these pumps can be located by slightly pressuring the
system and painting the suspected area with a thick soap
solution. Escaping air will produce soap bubbles.
3.30 OPERATING PRESSURE RANGE
3.31
The Vacuum/Pressure Pump are designed to be run from
slightly below atmospheric to their maximum vacuum level
on the intake side. The pumps also may be run from
atmospheric to their maximum rated pressure rating.
Consult the Specification Table for the ratings of your
specific model (See Section 6, Specifications).
3.40 SHUTDOWN PROCEDURES
3.41
After use, Cole-Parmer recommends the pump be run for
about 2 minutes disconnected from the vacuum process.
The air pumped through the mechanism will purge out
water vapor or droplets of water condensate that may have
formed on the inside of the pump. This purge of the pump
mechanism helps prevent corrosion. For turning of pump,
turn the switch to the OFF position.
14