- ページ 13

マザーボード Asus A8AE-LE AmberineMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Asus A8AE-LE AmberineM 18 ページ。

6.2

Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connecting

one end to the motherboard, connect the other end to the floppy drive. (Pin 5 is

removed to prevent incorrect insertion when using ribbon cables with pin 5 plug).

A8AE-LE

A8AE-LE Floppy disk drive connector

2. ATX power connectors (24-pin ATXPWR1, 4-pin ATX12V1)

These connectors connect to an ATX 12V power supply. The plugs from the

power supply are designed to fit these connectors in only one orientation. Find

the proper orientation and push down firmly until the connectors completely fit.

Make sure that your ATX 12V power supply can provide 8A on the +12V lead and

at least 1A on the +5-volt standby lead (+5VSB). The minimum recommended

wattage is 230W, or 300W for a fully configured system. The system may become

unstable and may experience difficulty powering up if the power supply is

inadequate.

A8AE-LE

A8AE-LE ATX power connectors

ASUS A8AE-LE (Amberine/AmberineM) Motherboard

FLOPPY1

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

PIN 1

ATX12V1

GND

+12V DC

+5V Standby

ATXPWR1

+3 Volts

Ground

+12 Volts

+5 Volts

+12 Volts

+5 Volts

Power OK

-5 Volts

Ground

+5 Volts

Ground

+5 Volts

PSON#

Ground

+3 Volts

-12 Volts

+3 Volts