- ページ 2
錠前 Dorex TECNICA DESIGN 200TRのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Dorex TECNICA DESIGN 200TR 2 ページ。 Deadbolt
ページを印刷する
5
INSTALL DEADBOLT - SINGLE CYLINDER
EXTERIOR CYLINDER
Tapped holes in the housing of exterior cylinder should be lined up with
the screw holes of the latch. Key hole should be in down position and
the tailpiece should be horizontal as shown.
Remove spacer ring inside the cylinder collar (see to the right).
It is only required for installations with a firecan.
CYLINDER
COLLAR
INTERIOR THUMBTURN
Align interior thumbturn base plate with cylinder tailpiece and assemble
using supplied mounting bolts. Place square or round rose over the base
plate, then washer and tumbturn. Secure thumbturn with set screw.
Do not use power tools when installing
door harware, excessive screw or bolt
tightening may affect installation or
functioning of the hardware.
INSTALLATION TEMPLATE
PLACE ON DOOR EDGE
Drill 1" (25.4 mm) hole on
door edge at the center of
the door thickness
INCH
MM
ROUND OR
SQUARE
MODEL
TABS
ROUND OR
SQUARE
MODEL
FOLD HERE
FOR BACKSET
2
/
" (60 mm)
3
8
1
/
1
/
1
/
3
9
3
4
16
8
FOR BACKSET
45
40
35
2
/
" (70 mm)
3
4
200TS / 200TR DEADBOLT
INSTALLATION WITH FIRECAN
The deadbolt requires modifcation prior to installation with a firecan on a
fire labelled wood door:
Firecan is NOT INCLUDED.
Must be ordered in conjunction with deadbolt.
a. Remove cylinder collar from
exterior cylinder.
b. Ensure spacer ring is
installed as shown.
c. Flip cylinder collar as shown and
reassemble exterior mechanism.
d. Insert Firecan into 2
hole as shown. You may have
to adjust the opening for a
proper fit.
e. Install exterior cylinder as
per Section 5.
f. Install interior thumbturn as
per Section 5. Ensure tabs
are INSIDE of the firecan.
Do not use template if not to scale.
To verify, confirm dimensions.
Installation Instructions
SPACER
RING
CYLINDER
COLLAR
FLIP
CYLINDER
COLLAR
/
" (54 mm)
1
8
2
/
" (54 mm)
1
8
200TS-TR-INST 2018-03
ROUND OR
SQUARE
MODEL
SPACER
RING
2/2