- ページ 9

火災警報器 bolid IPR 513-3MのPDF 付属マニュアルをオンラインで閲覧またはダウンロードできます。bolid IPR 513-3M 15 ページ。
bolid IPR 513-3M にも：取扱説明書 (2 ページ)

2.2.3 Mounting

The MCP is to be mounted to a flat vertical surface in

line with Buildings Codes and Regulations. The MCP rear

panel (base) is attached to the wall with two screws. The

front part of the housing is installed on the mounted base

after connecting wires to the terminal block. The wires that

pass under the rear panel should not be clamped by the MCP

housing.

Figure 2.2.3.1 shows the view of the MCP (without

the protective flip cover).

1: Hole to insert the key to reset the activated MCP;

2: Holes to insert the key to open the MCP housing;

3: Special key to reset the activated MCP / to open its housing;

4: Place to apply a seal.

Figure 2.2.2.2 Mounting Dimensions for the MCP

Figure 2.2.3.1. Parts of the MCP