No input signal to one or both channels:
Solution: select correct signal source using the input buttons
Verify that the input signal cables are properly connected.
Verify that the three - pole 6,3mm jack from the headphones is plugged deep enough.
Caution! Inside your CANOR SH-1 headphone amplifier there are no parts
or adjusting features that user can set or correct
Service
Should you encounter a problem which you are not able to alleviate or identify despite above
information, please contact your dealer for further advice. Only when the problem cannot be
resolved should the unit be sent to the responsible distributor in your country.
European Community Directives
This product is designed and manufactured in order to comply with existing laws of the
European Community. This product is certified by testing laboratory and bears the CE mark.
Revision 12.2008
Specification
Power output
Input impedance
Signal to noise
Frequency response 30Hz - 20kHz/-0,05dB (10Hz – 120kHz / -0,9dB) / 300 Ohms
Gain
THD
Headphone jack
Power supply
Dimensions WxHxD 210 x 295 x 88mm
Weight
400mW into 30 Ohms or 70mW into 300 Ohms
22 kOhms
>95dB unweighted ref. full output (106dB 'A' weighted ref. full output )
10,5dB
<0,05%
3-pole 6,3mm Ø phono socket
16V/1000mA AC
2.6 kg without power supply