- ページ 11

カードリーダー cantaloupe ePort Engage ComboのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。cantaloupe ePort Engage Combo 17 ページ。

PAGE 11

SYSTEM CONNECTION TO THE DEVICE

1. Now that the Engage device is secured to the vending equipment, it is time to connect the

MDB and DEX cables.

2. Connect the DEX cable to the DEX port on the vending equipment. There are several

areas inside of the vending equipment that house a DEX port, making it versatile where

you can connect your DEX cable. There are optional DEX Y cables that can also be used

for installation if necessary (see figure 2.5).

Note: If you choose to use a DEX port that is located on the door frame, you'll need

to take it apart and let the cable hang, otherwise it will hit the back of your vending

equipment which could damage the cable over time.

3. Connect MDB cable to the connection point directly from the main board. All other MDB

connections should follow after the Engage (plugged in 'first in line' to the board). If the

Engage is plugged in behind any other equipment, it could cause reporting or

communication errors.

4. Now that the cable is connected, power the vending equipment back on and check the

front of the equipment to make sure the power is connected correctly and is booting up.

Note: It may take several minutes for the machine to fully reboot, gather it's IP

Address, and load additional files to operate.

ePort Engage Combo Installation

figure 2.5

Section 02