- ページ 7

ソウ Bolton Tools BS-128HDRのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Bolton Tools BS-128HDR 16 ページ。 Horizontal and vertical metal cutting band saw

4. Remove left hand from bottom pulley and place it at the top aide of the

blade to continue the application on the upward pull on the blade.

5. Remove right hand from blade and adjust the position of the top pulley

to permit left hand to slip the blade around the pulley using the thumb

index and little finger as guides.

6. Adjust the blade tension knob clockwise until it is just right enough so

no blade slippage occurs. Do not tighten excessively.

7. Replace the blade guards.

8. Place 2-3 drops of oil on the blade.

BLADE GUIDE BEARING ADJUSTMENT

ATTENTION: This is the most important adjustment on your saw. It is

impossible to get satisfactory work form your saw if the blade guides are

not properly adjusted. The blade guide is daring on your metal. Cutting

Band Saw are adjusted and power tested with several test cuts before

leaving the factory to insure proper setting. The need for adjustment

should rarely occur when the saw is used properly. If the guides do get out

of adjustment, it is extremely important to read just immediately. If

improper adjustment in maintained, the blade will not cut straight, and if

the situation is not corrected it will cause serious blade damage.

Because guide adjustment is a critical factor in the performance of your

saw, it is always best to try a new blade to see if this will correct poor

cutting before beginning to adjust. If a blade becomes dull on one side

sooner than the other, for example, it will begin cutting crooked. A blade

change will correct this problem the guide adjustment will not. If a new

blade does not correct the problem, check the blade and guides for proper

spacing.

NOTE: There should be from 000 (just touching) 001 clearance between

the blade and guide bearings, to obtain this clearance adjust as follows.

1. The inner guide bearing is fixed and cannot be adjusted.

2. The outer guide bearing is mounted to an eccentric bushing and can be

adjusted.

3. Loose the nut while holding the bolt with an Allen wrench.

4. Position the eccentric by turning the bolt to the desired position of

clearance.

5. Tighten the nut.

6. Adjust the second blade guide bearing in the same manner.