ページを印刷するDRPB48V Operation Manual
TOOL OPERATION FOR SETTING BLIND RIVETS
1) After completing the start-up preparations, place the rivet mandrel into the nosepiece, and
holding the tool to insert the rivet into the pre-drilled hole of the work piece that needs to be
fastened.
2) Pull the tool trigger (#48) to set the blind rivet in its position on work piece.
3) After setting the rivet, the vacuum will suck the mandrel into the mandrel collector (#24)
automatically. Be sure to empty the mandrel collector (#24) regularly – half-full is full -
otherwise the tool will not release additional mandrels properly. While using the tool, be sure
always with the mandrel collector (#24) on the tool, in case a mandrel comes shooting out
from the back and causes injuries.
4) The force of the vacuum can be adjusted higher or lower by turning the knob on back of the
tool visible when the mandrel collector (#24) is removed:
5) The air adaptor hose (#53) provided with this tool has a sliding switch to pause the air supply.
TOOL MAINTAINANCE
In order to maintain optimum performance after several weeks of regular use, add a few drops
of hydraulic oil on the inlet of the air adaptor (#52) of the tool in order to reduce the friction of
the tool parts since the oil will be blown inside the tool when tool is in operation.