- ページ 6

リベット工具 Dafra DNP3212-2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dafra DNP3212-2 9 ページ。 Rivnut tool

After certain period of use, the tool stroke might be reduced, it shows the hydraulic oil of the pneumatic

tool is necessary to be refilled or changed:

1) To remove the screw by hexagon wrench:

2) To connect the air supply and to cover some cloth over the hole where the screw removed, then to

press the button and the oil will be leaked out from the tool:

3) To screw the oil inject adaptor (on oil injection tube set in the accessories pack) into the hole where

screw removed:

4) To use the oil injection tube (in the accessories pack) to inject the oil slowly until not able to refill, to

remove the injection tube and its adaptor, then clean the oil on the tool and tightly screw on the screw

back to the tool:

5) To test the tool stroke. If the stroke still not enough as it should be, it means there could be some air

in the oil cylinder when you refill the oil in the tool. Then the extra air needs to be released from the

tool.

To connect the tool with air supply, to pull the tool button 6 or 7 times, then loosen the screw, let the

extra air leaking out, then screw on the screw tight again: