ページを印刷するDRT510 Operation Manual
Setting a rivnut continued.
3. Hold the forward handle still and
rotate the rear handle right to left.
The rivnut will pull up and form a
flange on the rear side of your work
piece.
Do not pull the rivnut up too tightly as
you may strip the thread in the rivnut or
damage the tool mandrel.
4. When the rivnut is correctly installed,
move the ratchet switch to the
DOWN position.
5. Again holding the forward handle
still, rotate the rear handle clockwise
one turn to release the rivnut from
the mandrel.
PAGE 5