- ページ 12
ボート Dagger TouringのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dagger Touring 20 ページ。 Recreational kayak
Dagger Touring にも: オーナーズマニュアル (16 ページ), オーナーズマニュアル (12 ページ)
O
R
UTFITTING:
UDDERS
Some Dagger touring kayaks have a rudder
fitted. Rudders are operated by the foot
brace pedals which slide forward and back,
controlling the angle of the rudder.
RUDDER INSTALLATION
1
The rudder assembly is stored in the rear hatch.
Remove the split-ring and plastic washer from
the pintle (rudder post). Insert the pintle into the
vertical hole of the gudgeon (moulded-in rudder
mount). Replace the washer and split-ring.
Attach the rudder cables. To do this, thread the
2
'D'-shackles through the holes on each side of
the rudder assembly and re-tighten the pins.
Insert pintle into gudgeon
Rudder cable
with D-shackle
Gudgeon
Attach rudder
cables at both sides
12
RUDDER OPERATION
Sit in the kayak and check the footbrace pedal
positions. The pedals should be adjusted to
fit the length of your legs and equal distances
from the seat. Once adjusted, any slack in the
rudder cables should be removed by tightening
at the footbrace.
1
Release the bungee loop securing the rudder
blade so that it is free to lift.
2
Pull one of the balls on the rudder line until the
rudder hangs vertically downwards. Test by pushing
on the footrests pedals with your feet.
3
To stow rudder, pull the second ball to reset the
rudder on the deck.
Always secure the
rudder blade with the
bungee loop when
transporting your
kayak