- ページ 5

照明器具 Electra Light Beam 700のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electra Light Beam 700 20 ページ。

USER MANUAL - BEAM 300 / BEAM 700

operating.

-For protection from electronic shock, the fixture must be earthed!

-Install a suitable plug on a power cord, install overload devices. The earth has to be connected!

Prevent you and the safety of others by ultraviolet radiation and lamp explosion.

-Do not operate the moving head light with strong light without optical lens filter and can be

released directly.

-Danger! Install the lamp with the device switch off only. Make sure the temperature of light body

should not be obviously higher than the surrounding temperature.

Noted that change lamp, leave the device switch off until it has reached to room temperature.

-Avoid looking directly into the light source when the fixture was put power on.

Prevent you own and others burn or installation-spot catch fire.

-Avoid to both TDS (temperature detect switch) and fuse direct shock-circuit, for placement use

TDS and fuses of same type and rating only.

-Fixtures cannot be installed on combustible substances (alcohol, gasoline and paper), keep more

than 1m distance with wall for smooth air flow, so there should be no shelter for fans and

ventilation for heat radiation.

-The minimum distance between light output and the illuminated surface must be more than 1

meter .

-Never installation optical filter and others on the internal 3-lens.

-If the device has been exposed to drastic temperature fluctuation (e.g. transportation), do not

switch it on immediately. The arising condensa tion water might damage your device. Leave the

device switched off until it has reached room temperature.

-Please use original packaging if the device is to be transported. For safety reasons, please be

aware that all modifications on the device were forbidden.

-The maximum ambient temperature 40

Prevent you own and the safety of others by the device was crashed.

-Never lift the fixture by holding it by oneself.

-Always fix the fixture with an appropriate safety rope and holder .

-Anytime, installing and taking down the fixture, when rigging, de-rigging or servicing the fixture

staying in the area below the installation place, on bridges, under high working places and other

endangered area is forbidden.

-Light Source: Philips MSR 300 FASTFIT

-Input voltage: AC100-240 50-60Hz

-Control channels: 16/24CH

-XY Movement: Pan 540°(16 bit), Tilt 280°(16 bit)

-CMY color mixing system

-Color Wheel: 8 replaceable colors plus white, bi-direction revolving rainbow effects available

30 preset CMY color mixing wheels and color macro-asynchronous available

must never be exceeded.

TECHNICAL SPECIFICATIONS