- ページ 3

DJ機材 Electra Light CITY LEDのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electra Light CITY LED 4 ページ。 Led washer series 96*10w – rgbw – 4in1

ページを印刷する

SAFY INSTRUCTIONS

Thank you very much for your purchasing this device, please read

these instructions carefully, it includes important information about

the installation, usage and maintenance of the product.

Please keep this User Guide for future consultation. If you sell the unit to another

user, be sure that they also receive this instruction booklet.

Always make sure that you are connecting to the proper voltage, and that the

line voltage you are connecting to is not higher than that stated on the decal or

rear panel of the fixture.

This product is intended for indoor use only!

To prevent risk of fire or shock, do not expose fixture to rain or moisture.

Make sure there are no flammable materials close to the unit while operating.

The unit must be installed in a location with adequate ventilation, at least 20in

(50cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

Always disconnect from power source before servicing or replacing fuse and be

sure to replace with same fuse size and type.

Secure fixture to fastening device using a safety chain. Never carry the fixture solely

by its head. Use its carrying handles.

Maximum ambient temperature (Ta) is 104 °F (40

temperatures higher than this.

In the event of a serious operating problem, stop using the unit immediately. Never

try to repair the unit by yourself. Repairs carried out by unskilled people can lead to

damage or malfunction. Please contact the nearest authorized technical assistance

center. Always use the same type spare parts.

Make sure the power cord is never crimped or damaged.

Never disconnect the power cord by pulling or tugging on the cord.

Avoid direct eye exposure to the light source while it is on.

Warning!

Verify that the voltage select switch on your unit matches the line voltage applied.

Damage to your fixture may result if the line voltage applied does not match the

voltage indicated on the voltage selector switch. All fixtures must be connected to

circuits with a suitable Earth Ground.

CITY LED 96*10W-RGBW User's Manual

° C). Do not operate fixture at

LED DISPLAY AND KEYSETUP

The unit has a 4-digit LED display to configure its functions. This LED display has

four touch buttons: <MENU>, <UP>, <DOWN> and <ENTER>.

You can access these functions by using the four bottons. Here are functons of these

buttons.

<MENU>: this button is used to access the

menu or to return to a previous menu

option.

<UP>: this button is used to scroll through menu

options in descending order.

<DOWN>: this button is used to select and store the current menu or option within a

menu.

<ENTER>: this button is used to selects menu option.

Normally, the LED will display current DMX address code, as like: "DMX

Address: 001". Press<MENU> to enter the main menu; press <UP> or <DOWN> to

scroll in the menu or submenu options; Press <ENTER> to confirm your selection.

Any time press and hold <UP> or <DOWN>,the value will rapidly change and stop

when released. Once the value is set, press <ENTER> again to save and exit to the

main menu.

Turn on the fixture, and after initialization, it is ready for setting and working.

Please see the following table for setting information.

CITY LED 96*10W-RGBW User's Manual