- ページ 9
録音機器 Doug Fleenor Design PRESET 10 PORTABLEのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Doug Fleenor Design PRESET 10 PORTABLE 11 ページ。
Doug Fleenor Design PRESET 10 PORTABLE にも： オーナーズマニュアル (6 ページ)
ページを印刷する
3. Momentarily depress the PRESET SELECT button of the preset number you wish to
record.
4. Upon releasing the PRESET SELECT button, the red LED will no longer flash. This
indicates recording is complete.
Repeat steps 1 through 4 until you have recorded as many presets as required, up to
ten total.
RECORDING PRESET CROSSFADE TIME
A crossfade is a fade where the new preset levels entirely replace the previous levels.
Each of the ten presets can have its own unique crossfade time. Crossfade times
default to two seconds.
Note:
Crossfade times range from a minimum of 0 seconds to a maximum of 999 seconds
(16 minutes and 39 seconds).
To enter a crossfade time:
1. Disconnect the PRE10ETHER-A from any sACN sources on the same universes
as the PRE10ETHER-A.
2. Press the button of the preset you wish to edit. The green preset indicator LED
will illuminate.
3. Using a small blunt object (e.g. paper clip), momentarily depress the TIME
SETTING MODE recessed button located on the bottom most left of the
PRE10ETHER-A. The green LED indicator of the preset you selected to edit and
the yellow time LED above the recessed button that was just depressed will now
flash. You will have ten seconds to set the crossfade time. If you decide after
depressing the TIME SETTING MODE button that you do not wish to make an
edit, simply wait ten seconds or depress the TIME SETTING MODE button a
second time. No changes will have been made.
4. Enter the time in seconds using the PRESET SELECT buttons. Use PRESET
SELECT button 10 (OFF) to enter a zero (e.g. 120 seconds is entered by
pressing PRESET SELECT button 1 followed by 2 then OFF). The time setting
command is completed by one of three methods:
a. Enter a three-digit time. The TIME SETTING MODE will exit upon the
entry of the third digit. The green preset indicator LED will illuminate
steadily and the yellow time LED will go off, indicating success. A one or
Page 9 of 10