- ページ 13

防犯カメラ Dahua AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dahua A 19 ページ。 Hdcvi eyeball camera
Dahua A にも：ユーザーマニュアル (18 ページ)

Step 1

Find the mounting template sticker from the accessory pack and stick it to the mounting

surface①.

Step 2

Drill screw holes (and the cable outlet hole if it needs to go through the mounting

surface) on the mounting surface as indicated on the mounting template, then insert

expansion bolts② from the accessory pack in the screw holes.

Step 3

The disassembly way of camera is divided into three types:



For model A and E, hold the pedestal③ tightly and keep the device⑤ upward,

rotate the fixing ring⑦ counterclockwise until you can detach it from above, and

then take off the pedestal③.

For model B and model C, loosen the locking screw⑨ with the supplied wrench⑧



and take off the pedestal③.

For mode D, press the Locking to take off the pedestal③.



Step 4

Adjust the location of the pedestal③ according to cable outlet requirement (top out or

side out), then pull the cable out through mounting surface or the side cable tray. Align

the screw holes on the pedestal③ to those on the mounting surface, then put in and

fasten the supplied self-tapping screws④ to attach the device⑤ to the mounting

surface.

Step 5

Connect the camera to power source, and then connect the device to the XVR device.

For PoC cameras: Connect the XVR device to power source, and then connect video

output port of the camera to the PoC XVR device or PoC transceiver.

Step 6

The assembly and adjustment way of camera is divided into three types:



For model A and E, put the fixing ring⑦ back to hold the enclosure⑥, leave some

spaces enough for you to adjust the device⑤. Aim the lens to the ideal angle (see

Figure 3-4) and fasten the fixing ring⑦.

Figure 3-4



For model B and model C, put the enclosure⑥ back on and adjust the locking

screw⑨ to hold it, leave some spaces enough for you to adjust the device⑤. Aim

the lens to the ideal angle and adjust the focus until you get clear image (see

Figure 3-5) and fasten the locking screw⑨.

In Figure 3-5, ① is the locking screw.

Assembly and adjustment of model A and E

Installation 7