- ページ 3

メディア・コンバーター Doug Fleenor Design DMX512のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Doug Fleenor Design DMX512 6 ページ。 Dmx512 to 0-10 volt analog converter

The DMX512 to Analog Converter is generally placed at the dimmer end of the control

cable. This way the control cable needs only three conductors. In retrofitting an

existing installation where the analog control cables are already in place, it may be

easier to place the Converter at the console end.

The control cable to the Converter should be designed for data communication. Cables

designed for this purpose may be called "RS-422" or "RS-485" cables or "Shielded

Twisted Pair" or "Low Capacitance Data Cable". Microphone cable is not designed for

this purpose and should not be used for control runs of over 200 feet.

TERMINATION The single most common cause of DMX512 problems is failure to

terminate the end of the control run with the proper termination resistor. If the

Converter is the final device on the control run its feed through connector should be

terminated with a 120 ohm resistor between pins 2 and 3. You may make a termination

plug by soldering a 120 ohm 1/2 watt resistor between pins 2 and 3 of a 5 pin male XLR

connector or you may purchase a terminator ready made from a Doug Fleenor Design

dealer. For more information on termination see Appendix A "Why Terminate", a paper

presented at the 1995 Lighting Dimensions International trade show.

The cabling between the Converter and the dimmers is not as critical. Any quality wire

may be used. The size or gauge of the wire is more of a mechanical consideration than

an electrical one. Almost any gauge wire will work electrically but a larger wire will be

less likely to break. Any size thicker than 22 gauge should provide reliable service.

The Converter uses 100 to 120 Volts, 50 or 60 Hertz, at less than 1/10 Amp

(approximately 6 Watts). Plug it in to a grounded outlet for maximum safety. The

Converter may have been modified to operate on 240 Volts in which case the power

cord is labeled "Wired for 240 Volts".

The Converter uses the Male 5 pin "XLR" style connector specified in the DMX512

standard for its input. A Female feed-through connector is supplied to loop the

incoming DMX signal on to other devices. There is no isolation between the input and

output DMX connectors.

The pin outs for the 5 pin "XLR" are:

pin 1:

pin 2:

pin 3:

pin 4 & 5:

There is no electrical connection between the DMX input common and the analog

output common. This is accomplished by the use of a 2500 Volt optical isolator. This

eliminates the possibility of ground loops and provides added protection for the console

against dimmer failure and electrical storm damage.

The output of the Converter is supplied on a female DB-25 connector.

SETUP AND CONNECTIONS

DMX512 common

data -

data +

not used (but connected to feed through connector)