- ページ 8

コントロールユニット Doug Fleenor Design Preset 10 ArchitecturalのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Doug Fleenor Design Preset 10 Architectural 8 ページ。

PLAYBACK OF PRESETS

Presets can be played back in one of two ways: a crossfade to a static preset, or an autofollow of all ten

presets. A crossfade is a change from the current preset to the newly selected one. The time taken to

fade from the current preset to the new preset is taken from the newly selected preset. Once the fade has

completed, it will remain in that preset (static) until another preset is selected. When the autofollow

method of playback is used, once the fade time of the currently fading preset is completed, the next

preset is automatically selected.

To begin a crossfade between presets, momentarily press the preset select button of the preset you wish

to play.

To begin autofollow of all ten presets, press and hold the preset select button of preset number 1

(approximately 5 seconds) until all the LEDs flash once. Once the fade time of a preset is complete, the

next preset will be selected automatically. When preset number 10 (OFF) has been reached, the next

preset to be selected will be preset number 1.

To exit autofollow, momentarily press any preset select button.

Note:



If a static preset is playing at the time power is lost, the Preset 10 will return to that preset when

power is restored. The fade time will begin with all 512 channels at 0% and fade up in the time

recorded to that preset.



If the Preset 10 was in autofollow playback at the time power was lost, the Preset 10 will resume

autofollow playback beginning with preset number 1.



To bypass unused presets in autofollow mode, set the crossfade time for those presets to 999

seconds. This means the longest autofollow fade time is 998 seconds.

PRESET NUMBER 10 (OFF) – SPECIAL FUNCTION

When the levels stored in preset number 10 (OFF) are all zeros, a special function is enabled. When preset

number 10 (OFF) is selected and the crossfade has completed, the Preset 10 will stop sending DMX512.

By ending DMX512 transmission, many moving lights and dimming systems will enter their standby mode.

This feature can be disabled by recording any non-zero level on any channel into preset number 10 (OFF).

LIMITED MANUFACTURER'S WARRANTY

Products manufactured by Doug Fleenor Design (DFD) carry a five-year parts and labor warranty against

manufacturing defects. It is the customer's responsibility to return the product to DFD at the customer's

expense. If covered under warranty, DFD will repair the unit and pay for return ground shipping. If a trip is

necessary to the customer's site to solve a problem, the expenses of the trip must be paid by the

customer.

This warranty covers manufacturing defects. It does not cover damage due to abuse, misuse, negligence,

accident, alteration, or repair by other than by Doug Fleenor Design.

Most non-warranty repairs are made for a fixed $50.00 fee, plus shipping.

Page 8 of 8