- ページ 19

アクセサリー Baumer GNAMG. 213P SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Baumer GNAMG. 213P Series 19 ページ。 Inclination sensor with profibus-dp interface

Baumer GNAMG. 213P Series マニュアル
7.2.5.

Terminal assignment

Pin M12
Terminal
Pin 1
UB
Pin 3
GND
Pin 2
A
Pin 4
B
M12 connector
for serial data line
male
female
Terminals the same designation are connected to each other internally and identical in their functions. The
maximum load of the internal clamps UB-UB and GND-GND is 1 A each.
(A and B are each isolated with 100 nH inductivity for 12 MBaud operation).
Carefully press the cover of the inclination sensor over the sealing rubber, taking care not to tilt it.
The cover must fully rest against the base plate.
Tighten both the fastening screws firmly in the same direction.
The inclination sensor housing and braided shield of the connecting cable are only ideally connected if the
cover is resting fully against the base plate (positive locking).
7.2.6.

Status indicating elements (LEDs)

Bus cover provides at rear an integrated DUO LED.
Colour
LED green continuous
LED yellow continuous
7.2.7.

Profibus cable

EN 50170 specifies two types of cables, A and B. Cable type B is obsolete and should no longer be used
for new applications. With cable type A , all transmission rates up to 12 MBaud can be used.
Features
Shaft resistance in Ohm
Operating capacity (pF/m)
Loop resistance (Ohm/km)
Core diameter (mm)
Core cross section (mm)
Transmission speed depending on cable length
Baud rate
9,6
in kBaud
Cable
1200
length in m
Baumer_GNAMG_Profibus_MA_EN
07.18
Significance
Supply voltage 10...30 VDC
Ground terminal for UB
Negative serial data line
Positive serial data line
for power supply
Status
Inclination sensor is in mode „Data_Exchange"
Inclination sensor in ramp-up status or less bus contact
19,2
93,75
187,5
1200
1200
1000
Data
135 to 165 at 3 to 20 MHz
Less than 30
Less than 110
Greater than 0,64
Greater than 0,34
500
1500
400
200
19/19
3000
12000
100
100
Baumer IVO GmbH & Co. KG
Villingen-Schwenningen, Germany