- ページ 8

防犯カメラ Dahua DH-IPC-PDBW8800のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dahua DH-IPC-PDBW8800 17 ページ。 Hd panoramic multi-sensor network

Dahua HD Panoramic Multi-sensor Network Dome Camera Quick Start Guide

1.3 Alarm Setup

Note

This function is only supported by some models.

The following figure shows the Alarm setup screen.

To set up the Alarm input and output, do the following:

1. Connect alarm input device to the alarm input port of I/O port cable.

2. Connect alarm output device to the ALARM_OUT and ALARM_OUT_GND ports of I/O port

cable.

Alarm output is the relay switch output, and alarm output port can only be connected to NO

(normally open) alarm device.

3. Open the WEB, set alarm input and output correspondingly in alarm setup. Alarm input on

the WEB is corresponding to that of the device I/O port cable. When there is alarm, alarm

input device will generate signal of high and low level. Set corresponding NO and NC inputs.

Figure 1-2 Device dimension (unit: mm)

Figure 1-3 Alarm setup