- ページ 12

Figure 2-2

Step 3

Please take out the installation position map from the accessories bag, and then paste it on the ceiling

or the wall according to your monitoring area requirements.

Step 4

Find "cross" signs on the map, and dig three plastic expansion bolts holes on the installation surface

and then insert three expansion bolts into the holes. Secure these three bolts firmly.

Step 5

Adjust the device installation pedestal to the proper position and then pull cable through the exit hole

on the installation surface. Align the three screw holes in the device pedestal with the three plastic

expansion bolt holes in the installation position. Put the three installation screws into the three plastic

expansion bolts and secure them firmly. Fix the pedestal on the installation surface.

Step 6

Adjust the lens to the needed angle according to the application requirements of the location.

Hold the screw location of the rotation bracket on both sides, turn the rotation bracket horizontally,

adjust the lens direction horizontally to the target position; unscrew the two locking screws on both

sides (do not remove them completely, just make them loose), hold the IR light decoration cover to

make the lens rotate vertically, adjust the vertical direction of lens to a proper monitoring angle, then

tighten the locking screws on both sides; Hold the IR light decoration cover to rotate horizontally,

adjust the image and adjust the lens horizontal direction to the targeted location.

Note:

Range of adjusting lens angle: vertical rotation direction (0°～+65°), horizontal rotation direction

(0°～+355°), image horizontal rotation direction (0°～+355°).

Figure 2-3