- ページ 11

Dahua HD IR Waterproof Fixed Network Camera Quick Start Guide

2 Device Installation

Note:

Please make sure the installation surface can min support the 3X weight of the camera

and the bracket.

Please follow the steps listed below to install the device. Please refer to Figure 2-1 for reference.

Step 1

Aim the installation holes of the device enclosure bottom at the installation holes on the front end

of the wall-mounted bracket, then insert the screws into the screw holes and secure them firmly,

and fix the device on the installation bracket.

Step 2

Mark the bracket installation holes on the installation surface and dig four expansion holes on the

marked holes of the installation surface, then put the four expansion bolts into the installation

holes and secure them firmly.

Step 3

Aim the four screw holes on the wall-mounted bracket bottom at the four installation holes on the

installation surface, then put four fixing screws into the four screw holes on the bracket bottom

respectively and secure them firmly, finally fix the bracket on the installation surface.

Note:



Some devices don't support Micro SD card function, which can't be applied to this chapter.



Micro SD card installation mode is different according to different devices; the Figure 2-2 is

for reference only. Please refer to the actual product.



Please cut off the power and turn off the device before installing Micro SD card.

Open the lower flip of the device, then you can see the lens, SD card, and five-direction button

and reset button.

Note:

Figure 2-1 Device installation illustration