- ページ 14

ネットワーク・ルーター Asus AAM6020BI-T4のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Asus AAM6020BI-T4 38 ページ。 Cpe (customer premises equipment) adsl 4 port router

ページを印刷する

4.3.1

Wide Area Network connection

On the other side of the router is where your Wide Area Network (WAN) connection; also referred to as a

broadband connection. This WAN connection is different for every WAN supplier. Most of the

configuration you will perform will be in this area. Local Area Network Connection(s)

4.3.2

Local Area Network connection

On one side of your router, you have your own Local Area network (LAN) connections. This is where you

plug in your local computers to the router. The router is normally configured to automatically provide all

the PC's on your network with Internet addresses.

4.4

Configuring the WAN

Before the CPE will pass any data between the LAN interface(s) and the WAN interface, the WAN side of

the modem must be configured. Depending upon your DSL service provider or your ISP, you will need

some (or all) of the information outlined below before you can properly configure the WAN:

• Your DSL line VPI and VCI

• Your DSL encapsulation type and multiplexing

• Your DSL training mode

For PPPoA or PPPoE users, you also need these values from your ISP:

• Your username and password

For RFC 1483 users, you may need these values from your ISP:

• Your DSL fixed Internet IP address

• Your Subnet Mask

• Your Default CPE

• Your primary DNS IP address

Since multiple users can use the CPE, the CPE can simultaneously support multiple connection types;

hence, the user must set up different profiles for each connection. The CPE supports the following

protocols:

• DHCP

• RFC 2364 PPPoA

• RFC2516 PPPoE

• Static

• Bridged

• CLIP

4.4.1

New Connection

A new connection is basically a virtual connection. Your CPE can support up to 8 different (unique) virtual

connections. If you have multiple different virtual connections, you man need to utilize the static and

dynamic routing capabilities of the modem to pass data correctly.

4.4.1.1 Bridged CPE profile and Connection

A pure bridged connection does not assign and IP address to the WAN interface. NAT and firewall rules

are not enabled. This connection method makes the router act as a hub, and just passes packets across the

WAN interface to the LAN interface.

To configure the CPE as a bridge, from the Home page, click on Setup and then click on New Connection.

The default PPPoE connection setup is displayed. At the Type field select Bridge and the Bridge

connection setup page is displayed (see Figure 4). Give your Bridge connection a unique name; the name

must not have spaces and cannot begin with numbers. In this case the unique name is called bridge1.

Select the encapsulation type (LLC or VC); if you are not sure just use the default mode. Select the VPI

AAM6030BI User Manual