- ページ 12

扇風機 Electric Co AV06のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electric Co AV06 15 ページ。 Vitroceramic fan heater

ページを印刷する

GENERAL DESCRIPTION

Adjustable thermostat

Pilot light

C. 90º horizontal oscillation button

D. Handle

Operation button: on/off, fan mode and 2 heating levels (750/1500W)

TECHNICAL SPECIFICATIONS

Supply voltage: 230V~ 50Hz

Power: 1500W (750/1500W)

PREPARING FOR USE

Lightweight and easy to carry, the Vitroceramic Heater AV06 provides a quick and uniform

air flow distribution.

Before Using

- Make sure that all the packaging materials have been properly removed before use.

Operation

- Make sure that the appliance is switched off on operation button (E), before connecting it

to the wall socket.

- Fully extend the supply cord and connect the appliance to the wall socket.

- Select the fan mode or the desired heating level on the operation button (E):

- Fan mode - turn the operation button (E) to position "

working on the fan mode;

- Medium heating level (750W) - turn the operation button (E) to position " ";

- High heating level (1500W) – turn the button (E) to position "

- Adjust the temperature on the adjustable thermostat (A). Turn it clockwise to select a

higher temperature, and turn it the opposite direction to a lower temperature.

- The pilot light (B) turns on when the fan starts to work and turns off when stop working.

Note: on the fan mode the temperature is constant and cannot be adjusted.

- To switch off the appliance turn the button (E) to the off position "0".

- If you wish to move the appliance or if it is not going to be used for a long period of time,

remove the supply cord from the wall socket.

Safety thermal protector

- This appliance is equipped with a thermal protector which automatically switches it off in

the event of overheating.

- Whenever the thermal protector switches off the appliance disconnect it from the wall

socket and wait 15 to 20 minutes for it to cool down before switching on again.

", the appliance start to

Automatic Disconnection System in the Event of Falling Over

- This appliance is equipped with a contact button on the base, which switches off the

appliance it if fall over. Whenever the button is not in contact with the surface below, the

appliance will automatically switches off.

HINTS

- Keep doors and windows of the room you want to heat closed and make sure they are

well caulked, to minimize the heating loss.

TROUBLESHOOTING

- During use, if any irregularities are detected on the appliance's operation, check the

below table to understand the causes and solutions to resolve them. If not possible, please

contact the Customer Support Line or go to the store where the appliance was bought.

Problem

Possible Cause

The plug is not connected

correctly into the wall socket.

The appliance

does not switch on

when connected to

the wall socket.

The wall socket is damaged.

The overheat system was

The appliance

activated and turned off the

turns off.

appliance.

CLEANING

Cleaning

- Always disconnect the appliance from the wall socket and allow it to cool down

completely before any cleaning operation.

- Do not use abrasive cleaning agents or scrub pads, alcohol or solvents.

- Clean the appliance's exterior with a soft, clean and dry cloth.

- Use a vacuum cleaner or a brush to remove any dust on the grid.

Note: when cleaning, do not disassemble the grid or any other part of the device.

- Never immerse the appliance in water or other liquid.

Storage

- Store this appliance in a dry and well ventilated place, preferably inside the original

packaging to avoid dust accumulation on the grids.

Solution / Hint

Connect the plug correctly into

the wall socket.

Check if the wall socket is

damaged and connect the

appliance to another that works

properly.

Check the appliance's openings

and remove any objects that

are blocking them.