- ページ 2

電動工具 Electric Eel Model SのPDF お客様の安全および操作マニュアルをオンラインで閲覧またはダウンロードできます。Electric Eel Model S 2 ページ。 25 ft. electric drain cleaner

ページを印刷する

Follow the steps below to operate the tool

Step Action

The Drain Cleaner is equipped with a KEYLESS type chuck. To operate chuck, grasp the outer body

of the chuck with your hand and twist it counterclockwise to OPEN: Twist clockwise to CLOSE.

HOW TO HOLD THE DRAIN CLEANER:

Place one hand on the pistol grip handle at the rear of the tool and keep the other hand on the red hand

guard at the front of the tool BEHIND the chuck. KEEP CLEAR of the rotating drum while tool is in operation.

TO START AND STOP DRAIN CLEANER:

CAUTION: Make sure the TRIGGER SWITCH on tool is OFF. Make sure that you are plugging into a

household 120 Volt Ground Fault Interrupted Circuit. Make sure cable is fully retracted into drum.

Connect Drain Cleaner to power circuit.

1. Squeeze TRIGGER SWITCH to start motor. Release trigger switch to stop motor. The motor speed will

increase the more the trigger switch is squeezed.

2. The REVERSING SWITCH is located above and in front of the trigger switch and changes direction of

the cable.

FORWARD rotation is used when feeding the cable into the drain and when removing cable from drain.

REVERSE is ONLY used to free up the cable if it gets hung up.

ROTATION DIRECTIONS:

1. FORWARD rotation is used when feeding the cable into the drain and when removing cable from drain.

REVERSE is ONLY used to free up the cable if it gets hung up.

2. FOR CLOCKWISE ROTATION release trigger switch and allow drum to stop rotating, push the reversing

switch to the left side of the Drain Cleaner.

3. FOR COUNTERCLOCKWISE ROTATION release trigger switch and allow drum to stop rotating, push

the reversing switch toward the right side of the Drain Cleaner.

CAUTION: Allow drum to completely stop rotating before changing direction of rotation. NEVER attempt to

change direction of rotation while switch is ON. You may damage the switch interlock feature.

INSERTING CABLE INTO DRAIN:

1. Make certain that the reversing switch is set for FORWARD rotation, and that the power source matches the

voltage on the tool's specification plate. Connect Drain Cleaner to Ground Fault Circuit Interrupter power source.

2. Open chuck and pull out approximately one foot of cable.

3. Close chuck tightly.

4. Operate Drain Cleaner at low speed while slowly feeding cable into drum.

NOTE: If cable binds, STOP the tool immediately. Set switch for reverse rotation. Operate motor slowly

while pulling back lightly on the Drain Cleaner to free the cable. DO NOT operate the tool in reverse for

extended periods. Extended reverse operation can damage the cable.

5. Continue to operate tool at low speed while repeating Steps 2 thru 4 to feed additional cable into the

drain until the obstruction is cleared.

6. A continuous flush of water to clean tool, cable and sewer line as cable is retrieved is recommended.

OPERATOR'S MANUAL and MORE INFORMATION AVAILABLE AT:

Tool Application:

Clears 1-1/4" through 2-1/2" diameter drain lines up to 25 Ft.

Variable speed electric drill unit for sinks, laundry tubs and

small drains.

Cables Available for the Model S:

IC Cable: Genuine galvanized aircraft wire inner core

EIC Expanded End Inner Core Cable: Tighten down and break

through tough clogs while resisting kinks

E Expanded End Cable: Open kitchen and bath drains or go

down vents

ALL CABLES Constructed of Certified Music Wire

Toll-Free: 800-833-1212