- ページ 14

メディア・コンバーター Baumer GBMMSのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Baumer GBMMS 41 ページ。 Absolute encoder with powerlink interface
Baumer GBMMS にも：マニュアル (19 ページ), マニュアル (26 ページ), マニュアル (24 ページ), マニュアル (19 ページ)

ページを印刷する

Important note for multiturn encoder operation

This encoder supports „Endless Operation" automatically if required.

Thus, there are no special requirements for the encoder parameters "total measuring range" and

"measuring units per revolution" to stand in a certain ratio.

With endless operation active, the encoder shaft must not rotate when the encoder is not

powered. In those cases where powerless motion cannot be avoided, the encoder has to be

referenced (presetted) after each power-up. With Endless Operation inactive, the encoder shaft may

rotate unlimited when encoder not powered.

How to determine if „Endless Operation" is in use:

Multiply the encoder's „max. possible revolutions" (depending on encoder 16 bit = 65536 or 13

bit = 8192) by your chosen parameter „measuring units per revolution".

Divide this value by your chosen „total measuring range".

If there is a division remainder, endless operation is in use.

Example for parameters without endless operation:

Maximum possible revolutions

Measuring units per revolution

Total measuring range

Calculation:

Example for parameters with endless operation:

Maximum possible revolutions

Measuring units per revolution

Total measuring range

Calculation:

Maximum Failures Master lifesign

Designation of the maximum number of tolerated failures in master lifesign transmission in output

word STW2. Upon exceeding the number of tolerated failures an error signal is output in G1_XIST2

which has to be acknowledged.

Any monitoring of the Master lifesign will only take place respectively begin if the values transmitted

by the control in master lifesign are unequal to zero.

Hex parameterization

The hexadecimal data described only reflect the actual settings in the form they are transmitted to the

encoder and by no means should be altered in any way.

Manual_ProfibusDPV2_BIDE_EN.docx

22.11.12

65536

(16 bit multiturn)

3600

29.491.200

(8192 x 3600)

65536 x 3600 / 29.491.200 = 8 (no remainder)

65536

(16 bit multiturn)

3600

100.000

65536 x 3600 / 100.000 = 2359 remainder 29600

14/41

Baumer IVO GmbH & Co. KG

Villingen-Schwenningen, Germany