- ページ 14

メディア・コンバーター Baumer Hubner Berlin PMG10のPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。Baumer Hubner Berlin PMG10 32 ページ。 Absolute encoder
Baumer Hubner Berlin PMG10 にも： 取付・取扱説明書 (32 ページ), 取扱説明書 (44 ページ)

ページを印刷する
Baumer Hubner Berlin PMG10 取付・取扱説明書
MOUNTING
4.3
Maximum permissible mounting tolerance when the Baumer Hübner K 35 spring
disk coupling is used
Devices with a solid shaft should be driven through the Baumer Hübner K 35 spring disk
coupling (accessory), that can be pushed onto the shaft without axial loading�
i
The figure below shows the device with EURO flange B10, the same maximum
permissible mounting tolerances are valid with housing foot B3�
)
The device must be mounted on the drive with the least possible angular error and
parallel misalignment�
)
Risk of damaging the ball bearings
Coupling components must not be driven onto the shaft with improper force (e� g�
hammer impacts), because of the risk of damaging the ball bearings�
Admissible
parallel misalignment
* With insulated hub
All dimensions in millimeters, unless otherwise stated�
14/32
2-10
Admissible
angular error
MB261EN - 11196414, 21A1, Baumer_PMG10-Inc_EN_202103_MI_11196414
Admissible
axial movement
±0.7 (±0.3*)