- ページ 7
自動車アクセサリー Douglas Dynamics Fisher Minute Mount 2 XLS 50810のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Douglas Dynamics Fisher Minute Mount 2 XLS 50810 17 ページ。 Snowplow
ページを印刷する10. With the vehicle parked on a solid level surface,
measure the distance from the center of the
connecting pin hole to the ground. Using this
measurement refer to the hole selection chart and
determine which hole should be used to attach the
headgear to the A-frame.
Center of
Connecting
Pin Hole
Measure
this distance
Pushplate Height
(hole center to ground)
17" to 19"
15" to 17" (typical)
13" to 15"
11. Lower the jack leg in the headgear assembly so
that six complete slots are showing through the
top of the headgear cross bar. Release the jack
lock to hold the jack in place. Place the headgear
assembly on top of the A-frame assembly so the
headgear is tipped backward and the jack leg is in
6 Slots
Lit. No. 50579, Rev. 02
Rear
12. Position the headgear so that the holes in the
Hole
Top
Middle
Bottom
13. If the lowest set of holes in the push assembly are
7
between the A-frame and push assembly. Attach
the jack handle to the jack with a 3/8" lock washer
and nut.
Jack Handle
Jack Lock
headgear are aligned with the previously selected
holes in the push assembly. Attach the A-frame
to the headgear assembly with two step pins and
1/4" x 1-1/2" cotter pins. Insert the step pins from
the outside of the headgear.
Step Pin
Cotter Pin
used, the stacking stops attached to the lift frame
can be removed.
50600, 50810
Nut
3/8" Lock Washer
Jack
April 15, 2010