- ページ 11

自動車アクセサリー Douglas Dynamics SnowEx HDV 77780のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Douglas Dynamics SnowEx HDV 77780 16 ページ。 Snowplow

OPERATIONAL TEST AND FINAL ADJUSTMENTS

5. Adjust the position of the hose brackets so that

the hoses loop out and away from the center of

the T‑frame as shown in the photo below. Tighten

the 1/4" locknut to prevent the hose brackets from

turning.

Hose Wrap

6. Install the provided hose wrap as shown above

to prevent the hoses from chafing and premature

wear.

NOTE: Failure to complete the installation of

the hose brackets and hose wrap may result in

premature wear and damage to the hoses.

AeroShell

is a registered trademark (

Lit. No. 52592, Rev. 04

) of Shell Oil Company.

Turn the control ON and raise and lower the

snowplow several times. With the plow in the

raised position, fully angle the snowplow from right

to left several times. Activate the control FLOAT

function and make sure the blade is lowered

completely to the ground. Turn the control OFF.

Do not mix different types of hydraulic fluid.

Some fluids are not compatible and may cause

performance problems and product damage.

8. Remove the filler plug and check the fluid

level. The fluid level should be 1"–1-1/2" below

the fill hole. If additional fluid is needed, add

SnowEx

Rapid Action Hydraulic Fluid rated

to –40°F (–40°C), or other fluid conforming to

Military Specification MIL-H-5606 A, such as

Mobil Aero HFA or Shell AeroShell

fluid is 1"–1-1/2" below the fill hole.

NOTE: Loosen the breather slowly to relieve any

pressure in the reservoir.

9. Replace and tighten the breather.

CAUTION

Fluid 4 until

July 15, 2020