- ページ 11

スプレッダー Douglas Dynamics SnowEx V-Pro SP-2000のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Douglas Dynamics SnowEx V-Pro SP-2000 17 ページ。 Utv hopper spreader

ページを印刷する

Vehicle Control Harness Installation

Choose a mounting location where the control will

be within easy reach of the vehicle operator and

will not restrict access to vehicle controls or vehicle

instrumentation. Do not mount the control in areas

prohibited by the vehicle manufacturer for crash

worthiness. See the vehicle's owner's manual or

service manual for details.

NOTE: You may want to contact Technical Support

before mounting the control if you prefer not to

drill holes into the dashboard.

CAUTION

Before drilling into dash, verify no harnesses,

relays, or other vehicle components can be

damaged by drilling.

1. Install the control bracket in the mounting location

using the provided tapping screws.

2. Install the control to the control bracket using

1/4" x 1-1/2" cap screws, nylon washers, and

steel washers.

3. Connect the harness to the back of the control.

Cable tie loose control harness securely below the

ﬂ oor pan. Do not mount close to any heater vents.

4. Connect the spreader power cord to vehicle main

power plug mounted at the rear of the vehicle.

Lit. No. 76451/76452/76453, Rev. 04

WIRING AND HARNESS INSTRUCTIONS

5. Push the ON/OFF switch on the control to check

for power. After power has been conﬁ rmed, push

the ON/OFF switch again to turn the control

OFF. The electrical portion of the installation is

complete.

NOTE: Use dielectric grease on all electrical

connections.

NOTE: In the oﬀ -season, remove the control and

store in a cool, dry place. The interior summer

temperatures could damage circuit board and

void warranty.

NOTE: Do not modify harness length. Any

modiﬁ cations will void warranty.

• Apply dielectric grease to all external connections.

• Read lead labels before attaching to power source

or ground.

• No other devices may be spliced into wiring

harness.

• Any repairs to wiring harness must be done with

heat-shrink butt connectors.

February 24, 2020