- ページ 8

スノーブロワー Douglas Dynamics SnowEx Automatixx SPEEDWING 77840のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Douglas Dynamics SnowEx Automatixx SPEEDWING 77840 17 ページ。

Insert the threaded end of the cable through the

driver-side pivot bushing from the center out.

Slide the cable through the spring until the eyelet

hole lines up with the driver-side mounting clevis

on the A-frame. Insert the eyelet into the clevis

and secure with a 5/8" x 2-5/16" clevis pin and

1/4" x 1-1/2" cotter pin. Repeat on passenger's side.

5/8" x 2-5/16"

Clevis Pin

8. Assemble a 3/4" hex nut and 3/4" jam nut loosely

onto the threaded end of the driver-side cable.

3/4" Jam Nut

Thread the nuts on just ﬂ ush with the end of the

cable. Repeat on the passenger's side.

NOTE: Final adjustment of the cables will

take place in the Operational Test and Final

Adjustments section of this document.

Lit. No. 52308, Rev. 06

INSTALLATION INSTRUCTIONS

1/4" x 1-1/2"

Cotter Pin

Cable

3/4" Hex Nut

9. Stand the blade and A-frame assembly upright and

support it in a level position using a block under the

main A-frame tube. Install the blade guides using

5/16" x 1" cap screws and 5/16" locknuts.

Blade

Guide

5/16" x 1"

Cap Screws

5/16"

Locknuts

May 1, 2021