- ページ 4
照明器具 Douglas Dynamics DD 99494のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Douglas Dynamics DD 99494 6 ページ。 Strobe light kit stainless steel hopper spreaders
ページを印刷する99494
3. The strobe light kit contains two harness
assemblies: 56" and 72". Determine your harness
routing and connect the appropriate harness to
each strobe light.
4. Electric and Hydraulic Spreaders: Cut holes in
two of the break-thru plugs (one on each side of
the electrical enclosure) and feed the harnesses
into the enclosure. The holes should be sized to
form a tight seal around the harnesses.
Gas Spreaders: Route the harnesses into the
engine enclosure from the passenger's side, just
forward of the engine mounting plate, taking care
to position the harnesses where the engine cover
will not contact them when the cover is closed.
Electric Spreader – Full Size
Relay/Fuse Assembly
Gas Spreader – Full Size
Lit. No. 92945, Rev. 05
Relay/Fuse
Assembly Bracket
Break-Thru
Plugs
Relay/Fuse
Assembly
Relay/Fuse
Assembly Bracket
Electrical enclosure covers not shown.
5. Mount the relay/fuse assembly to the relay/fuse
assembly bracket by pushing the connector clip on
the back of the assembly into one of the holes in
the bracket. Secure the relay/fuse assembly to the
bracket by running a cable tie through the slots in
the bracket and around the relay/fuse assembly.
Gas Spreaders: For best fi t, install the strobe light
relay/fuse assembly in the farthest right or second
from right position on the assembly bracket.
Hydraulic Spreader – Full Size
Relay/Fuse
Assembly
3
0.35 & 0.7 yd
Hopper Spreaders
Bracket
Relay/Fuse
Assembly
4
Relay/Fuse
Assembly Bracket
Break-Thru Plugs
Break-Thru
Plugs
August 1, 2020