- ページ 6

照明器具 Douglas Lighting Controls Dialog WIR-3110のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Douglas Lighting Controls Dialog WIR-3110 11 ページ。 Ir setting unit

Setting a Dimmer Switch

Step 1 -

Switch Configuration

Using the UP/DOWN buttons, move the cursor until it highlights the 'Dimmer Switch' field.

Step 2 -

Dimming Type

Using the UP/DOWN buttons, move the cursor until it highlights the 'Type' field. Select the

dimming type (Dim an individual output channel or Dim a group) to apply to the switch that

you are programming by rotating the scroll wheel clockwise or counterclockwise.

Step 3 -

Assigning an Address

Using the UP/DOWN buttons, move the cursor until it highlights the 'Addr' field. Select

the address you wish to assign the switch by rotating the scroll wheel clockwise or

counterclockwise.

Step 4 -

Assigning an Output Channel

*Applicable only when programming an individual dimmer

Using the UP/DOWN buttons, move the cursor until it highlights the 'Ch' field. Select the

output channel you wish to assign the switch by rotating the scroll wheel clockwise or

counterclockwise.

Step 5 -

Writing Programming to a Switch

Using the UP/DOWN buttons, move the cursor until it highlights the bottom right field.

Rotate the center scroll wheel until 'Write' is highlighted. Point the Infrared transmitter

approximately 0.5" away from the IR lens of the switch being programmed and press the

center button of the IR Setting Unit. You will hear a single solid beep sound indicating that

the switch was successfully programmed.

PAGE 6

Setting a Dimmer Switch

universaldouglas.com