- ページ 22

サーバー Asus AP100のPDF ハードウェア・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Asus AP100 32 ページ。 Pentium ii startup server

II. System Components

SCSI Information

Your server can support up to 15 user installed single-ended SCSI devices.

Be sure to include both internal and external SCSI devices in your device

setup. Each SCSI device (both internal and external) must have a unique

address (or SCSI ID). Check your SCSI device documentation for instruc-

tions. Be sure to record all SCSI addresses so that you can prevent SCSI

address conflicts.

SCSI devices are connected together in a "chain" by cables. Internal de-

vices connect to the motherboard with a 50 pin or 68 pin flat ribbon cable.

External SCSI devices may be connected using an external SCSI connector

or SCSI card with an external connector. If there are more than one internal

or external devices, additional devices are connected with cables to form a

"daisy chain." Terminating the devices on the ends of the SCSI Bus "chain"

is necessary for SCSI devices to work properly. SCSI devices normally come

with its termination enabled by jumpers or dip switches. You must disable

these termination for devices in between the SCSI chain. Ultra2 devices do

not have a termination jumper and must be terminated using a terminator on

the SCSI cable. The terminator must always be on the end of the cable

which means that you cannot connect a device on the last connector.

All SCSI devices, including this motherboard with onboard SCSI, must have a SCSI

identification number that is not in use by any other SCSI device. There are sixteen

possible ID numbers, 0 through 15. The SCSI ID serves two purposes:

•

It uniquely defines each SCSI device on the bus.

•

It determines which device controls the bus when two or more devices try to use

it at the same time.

SCSI IDs on one channel do not interfere with the IDs on another channel. You can

connect up to 15 SCSI devices to this motherboard. You must set a SCSI ID number

(ID 0 to ID 15) for each device. Note that the onboard SCSI chipset is also a SCSI

device and will also require a SCSI ID number. SCSI devices vary in how they set the

ID number. Some use jumpers, others have some kind of selector switch. Refer to the

manual for any device you install for details on how to set its ID number.

The motherboard has an onboard 16bit single-channel SCSI chipset. SCSI ID 15

has the highest priority, and SCSI ID 0 has the lowest priority.

AP100 Hardware Reference Guide