- ページ 16

サーバー Asus AP8000のPDF ハードウェア・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Asus AP8000 44 ページ。 Dual pentium® iii xeon corporate server

• 3-1. Starting the Server

Turn ON the server by turning the power knob clockwise and pushing in-

wards momentarily. The power button will snap back when released be-

cause ATX power systems have an electrical ON/OFF switch unlike AT

systems which require a permanent ON or OFF position. If the Power On

LED does not light, make sure the power cord is connected to the system

unit and to a working grounded outlet.

IMPORTANT

The power switch only turns off DC power (power supply output).

To turn off AC power (power supply input), you need to unplug the

electrical cords from the redundant power supply.

• 3-2. LED Indicators

The LED indicators are located on the top-left edge of the front panel. The

Power LED lights when the motherboard receives power from the power

supply. Activity LED lights when there is activity from IDE or SCSI de-

vices connected to the motherboard. Fan #1-5 lights if the corresponding

fan stops turning.

Fan #1 Error (when lit)

Fan #2 Error (when lit)

Fan #3 Error (when lit)

Fan #4 Error (when lit)

Fan #5 Error (when lit)

LED Indicators on Front Panel

• 3-3. BIOS Setup

This server does not come with any pre-installed software. When booting

your server for the first time, make BIOS settings by following the mother-

board User's Manual.

NOTE

When installing Windows NT 4.0, use the Windows NT installation

disks. Installing from the CD will require you to pre-install SCSI driv-

ers by pressing F6 before setup begins. You may need device drivers

on a floppy disk in order to install devices during the Windows NT

4.0 setup. To use the onboard SCSI, you will need to copy Adaptec's

SCSI driver (from the provided support CD) onto a floppy disk

("Winnt", "Disk1", "Txtsetup.oem").

III. Basic Operation

Power LED

Activity LED

AP8000 Hardware Reference Guide