ページを印刷する• Press "DOWN" key, the value will go back one step; press and hold for 2 seconds, the
value will go back at an 8 step/second speed.
After setting, press "ALERTS" to confirm.
• If no key is pressed for 10 seconds, system will exit automatically to set status.
4.4 Tips
• If powered by batteries, press any key or make a sound (greater than 60 decibels) to wake
up the backlight (within 20CM).
• If powered by the adapter, sound control will be shut down, press "SNOOZE/LIGHT",
adjust backlight: Bright→normal→Shutdown→normal→bight (loop in sequence).
• If powered by the adaptor, when the alarm is on and the backlight is on at the same time.
The backlight turns off after alarm stopped.
• If powered by batteries, please change the batteries in case of dim display.
• Every time you turn on the weather station, the station needs a few days to learn the
pattern of the local barometer for more accurate weather forecast.
Solutions to the common problems of products
• Why does the temperature and humidity of the product show deviations from the real
temperature and humidity?
The product is calibrated by precision reference when it is manufactured, but each product
has a slight difference in their electronic material used to determine temperature and
humidity. Even if the product is calibrated, the measured data can't be as accurate as
standard references, this error is going to be less than 5%.
• Why does the product shows different outdoor indoor date when the transmitter and host
are put together?
Host and transmitter have a slight difference in their electronic material used to determine
temperature and humidity, and they are individually calibrated by precision reference when
they were manufactured, this error is also going to be less than 5%.
• Why does the Weather Station and outdoor sensor lose connection?
A. Radio signals Easily absorbed by metal objects and not easy to penetrate the wall,
therefore, the distance in actual use will be much shorter than 80 meters (theoretical
value ).
B. Host's receiving channel doesn't corresponding with outdoor sensor's channel.
C. There's similar signal in the environment, this signal will be automatically received by
host and occupy a channel.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.