- ページ 27

キャッシュカウンター Baumer NE210のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Baumer NE210 44 ページ。 Electronic preset electronic preset counter

Terminal assingment

3 Connecting

This section describes the terminal assignments, accompanied by an

example of a typical connection. Sections 3.1 to 3.5 contain specific

instructions and technical data relating to the individual terminals.

–

Count

End contact

max. 265 V

terminal - terminal /

- terminal

Terminal connection

Terminal

Function

Not assigned

Voltage supply (-)

Voltage supply (+)

Signal output - relay contact

Signal input A (track A)

Signal input B (track B)

Reset by external signal

Electronic output (choice of PNP or NPN logic)

Coding input for input logic

Sensor supply (-)

Sensor supply (+)

For protection against shock hazards as specified in EN 61010, stran-

ded conductors may only be connected using wire end ferrules with

insulating caps. Terminals which are not assigned in the factory must

not be otherwise assigned by the user. We recommend shielding

all encoder connecting leads and earthing the shield at one end.

Earthing at both ends is recommend to avoid RF interference or if

equipotential bonding conductors are installed over long distances.

Sensor connecting leads should not be laid in the same trunking as

the mains power supply cable and output contact leads.

www.baumer.com

NE210