- ページ 2

アンテナ Amphenol Procom 130000784のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Amphenol Procom 130000784 2 ページ。 3 db mobile glassfix antenna for the 450 mhz band
Amphenol Procom 130000784 にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

GF 404/...

1. BEFORE INSTALLATION

When selecting mounting location take into consideration: positions of back view mirror,

wiper blade paths and defrosting wires (when mounting on rear window). The driver's

view should not be obstructed.

Max. allowed curvature of the glass surface on the mounting spot is 2 mm deﬂection per

100 mm length.

Environmental- and car temperature must be above 15° C at installation and surfaces to

be glued must be dry and clean.

2. INSTALLATION

Do not use sealer on rubber gasket or other places.

3. AFTER INSTALLATION

Allow the silicone gluings to dry oﬀ 2 hours at a temperature above 15° C. To ensure full

strength of the glue, it is recommended to keep the whip oﬀ the mount for 24 hours.

4. TUNING INSTRUCTIONS

Insert a forward/reﬂection-type wattmeter between the transmitter and the antenna.

Key the transmitter and observe the forward and the reﬂected power.

Adjust the tuning screw on the matching unit until minimum returned power is obtained.

PROCOM A/S reserves the right to

amend specifications without prior notice

WARING - SAFETY PRECAUTIONS

Antennas mounted on the windscreen may cause relatively high ﬁeld strengths in the

passenger cabin and near the dashboard.

1. To prevent health hazard due to RF radiation, persons must not be closer than 30 cm

to the antenna whip (transmitter output power to the matching unit: 20 W). (DIN 57 848).

2. The RF signals at the dashboard may cause interference in electronic equipment

such as broadcast radio, computer automatics, braking systems, electronic ignition,

relays etc. Some cars are more susceptible to disturbances than others. It is the

responsibility of the installer to carry out a thorough check of the proper functioning

under any conditions of such circuits before ﬁnishing installation.

The supplied silicone adhesive contains acetic acid and fungicides. Keep out of reach of

children and dispose properly.

REINSTALLATION KIT

A reinstallation kit including all necessary parts for transfer of the antenna to another vehicle

is available under order No. »GF-RK« (130000329).

ASSEMBLY DETAILS

Page: 2 of 2

Last edited: 2019/04/14