- ページ 5
レシーバー Amphenol Procom PRO-DAR16のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amphenol Procom PRO-DAR16 15 ページ。 19” rack-mountable dual amplifier receiver multicoupler
ページを印刷する2.6
Reading this manual
Before installing or replacing of the PRO-DAR versions, this entire manual should be read
and understood. Incorrect installation and usage may damage the equipment.
3 Introduction
The typical function of an active receiver multicoupler is to distribute a received antenna
signal to a number of receivers,
without introducing any signal loss and interacting between the receivers.
A passive power splitter could be used to split the antenna signal for the required number of
receivers. However, this way each receiver will only get a part of the received signal power,
and the sensitivity of the individual receivers will be reduced.
If an active low-noise receiver multicoupler is used for antenna signal distribution,
an antenna signal virtually identical to the original one will be applied to each receiver,
as if the particular receiver was directly connected to the antenna exclusively.
This manual contains description, installation, and documentation of the Amphenol Procom
models PRO-DAR4, PRO-DAR8, PRO-DAR12 and PRO-DAR16, which are active receiver
multicouplers with one input (ANT) intended for connection of RF signal (antenna signal) and
4, 8, 12 or 16 identical outputs (RX1 to RX4/8/12/16) intended to provide RF signal (antenna
signal) for a similar number of individual receivers.
PRO-DAR models cover the frequency range 30 MHz to 960 MHz and can be used at any
frequency or frequency band within this range.
The PRO-DAR models of multicouplers can also be used for buffering and splitting any other
kind of RF signal within the specified signal dynamic range of the equipment.
4 Technical Specifications
Please refer to the PRO-DAR datasheet on
www.amphenolprocom.com
Page 5 of 15