- ページ 7

ヘッドフォン Amphony 2500のPDF ユーザー・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Amphony 2500 12 ページ。 5.8 ghz digital wireless headphones
Amphony 2500 にも：ユーザー・インストール・マニュアル (13 ページ), 機能比較 (1 ページ), 製品情報 (4 ページ), よくある質問 (5 ページ), 仕様 (4 ページ), トラブルシューティングマニュアル (5 ページ)

User and Installation Guide

Step 5

Operating the headphones

After powering up the transmitter, the transmit light will light for approximately

5 seconds while the transmitter initializes.

After initialization, the transmit light will go out.

Once audio is detected at any of the audio interfaces, the transmit light will

light and the transmitter will transmit the audio signal.

By default (or if no audio is present), the transmitter will select the analog

audio interface. As soon as a signal is detected at either one of the digital

interfaces, the transmitter will activate the appropriate interface and light the

corresponding interface indicator.

Set the volume control of the headphones to minimum. Then, switch on the

headphones and slowly increase volume.

After each use, be sure to switch off the headphones to extend battery life and

to prevent damage to the headphones from leaking batteries.

When no audio is present anymore, the transmitter will go into standby mode

after approximately 1 minute. The transmit light will go out. During standby

mode, no signal is transmitted. If the headphones are not used for an

extended period of time, remove the AC adapter from the power outlet.

Interface indicators

Transmit light

R R

Page 6

R R