- ページ 9

送信機 Amphony TX1のPDF ユーザー・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Amphony TX1 18 ページ。 Digital wireless audio transmitter / receiver

User and Installation Guide

Setting the transmitter volume control

The transmitter perfroms advanced analog-to-digital transmission of the

audio signal. In order to achieve maximum dynamic range and avoid clipping

of the audio, the transmitter volume control must be adjusted to your audio

source.

In order to properly set the transmitter volume control, turn the volume of the

device connected to the receiver to a low setting. Then feed a signal with the

highest possible volume into the transmitter. Set the transmitter volume

control to the highest level while there is still no clipping / distortion of the

audio signal. Then set the volume of the device connected to the receiver to

your desired level.

If the transmitter level is set too low, the dynamics of the transmission are

not fully used. If the level is set too high, audio clipping (distortion) will occur

inside the transmitter during the analog-to-digital conversion.

If the transmitter or receiver are not used for an extended period of time,

remove the AC adapters from the power outlet.

Do not connect the receiver audio output directly to passive

ATTENTION!

speakers or other low impedance drains as this may damage

the receiver! The receiver audio output cannot drive passive

speakers or headphones directly. For those devices, an

external amplifier is required.

Page 9