- ページ 2

薪ストーブ Dovre 700CBWのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Dovre 700CBW 5 ページ。 Cast iron wood stove

I N S T A L L A T I O N

Before commencing with the installation it is important that these instructions are read and fully understood.

The DOVRE 700CBW is a specially designed stove for burning wood only and has been tested and approved by the U.S. Environmental

Protection Agency (EPA) in accordance with their stringent woodstove emission limits. It is essential that the wood used is well seasoned (min 2

years) and has a maximum moisture content of 20%. If unseasoned wood is used, heat outputs will not be obtained and serious damage will

occur in the chimney and flueways. The DOVRE 700CBW incorporates a high technology combustion system to provide high efficiencies and

low atmospheric pollution

The dimensions of your new stove are illustrated in fig 1. Be

careful to ensure that your fireplace is going to accept the

appliance and that you have allowed for 30cms of hearth

space in front of the stove.

R E G U L A T I O N S

CHECK THAT YOUR INSTALLATION WILL BE IN

COMPLIANCE

WITH

CURRENT

BUILDING

REGULATIONS.

A S S E M B LY

As the Dovre 700CBW is constructed from heavy cast iron, it

is advisable for two people to assemble and position the

appliance.

1. Open the stove door and remove all loose parts within.

2. To assist with lifting, remove the side panels by lifting

and disengaging from the bottom and top pins. see fig 2.

3. Carefully lift the appliance from the wood pallet, taking

care not to slide or tilt the unit, and place in position on the

hearth.

4. Refit the side panels by firstly engaging in the top pins

and then positioning on the bottom pins.

5. For a top flue connection, attach the circular cast iron

collar to the aperture located at the top of the appliance,

using the nuts, bolts and washers supplied. Use a small

amount of fire cement to ensure an air tight seal before fixing.

For a rear flue connection, adopt the same procedure using

the rear aperture. Fit the cast iron circular cover plate to the

unused aperture again using a small amount of fire cement as

a seal. The cover plate is attached using the fixing bar and

nuts and bolts supplied. refer to fig 3.

Fit the front ash lip using the two 8mm x 30mm hex

headed bolts supplied. see fig 4.

I N S T R U C T I O N S

7 0 0 C B W

150

FIG1

FIG2

FIG3

DOVRE 10 YEAR WARRANTY

If the castings on this appliance should prove to be defective within ten years of the purchase date,

the faulty castings will be replaced free of charge, subject to the following conditions.

1. The purchaser shall complete the registration section below and return it within seven

days of purchase. Failure to return the registration could result in delays in processing any

claims.

2. The appliance shall have been installed in compliance with the installation instructions.

3. The appliance shall not have been used for the burning of unseasoned wood.

4. This warranty only applies to the appliance body castings and does not include renewable

components including grates, ashpans, glass, seals and baffle plates.

5. This warranty does not cover site visits and any claims should be notified to your dealer.

This warranty does not affect the Statutory Rights of Consumer Purchasers.

Please complete and return this section within seven days of purchase to:

Dovre Castings Ltd, Weston Works, Weston Lane, Tyseley, Birmingham B11 3RP.

NAME:

ADDRESS:

TELEPHONE NUMBER:

MODEL:

DATE OF PURCHASE:

DEALER: