- ページ 2

ラボラトリー機器 Ample Scientific Champion S-33のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Ample Scientific Champion S-33 4 ページ。

ページを印刷する

4. Centrifuge Operation

1. Turn on centrifuge using power switch located on the back of

centrifuge. The display panels should light up, accompanied by a

long 'beep'.

2. Press [Off] to open centrifuge lid. After the loud click indicating

unlocking of centrifuge, there will be a 3 second window before the

lid automatically re-locks.

3. Please make sure test tubes are tightly sealed before loading into

rotor buckets. Do NOT use buckets from another manufacturer or

interchange buckets from one centrifuge to another

4. Make sure loads are cross-balanced before centrifugation. Make

sure that test tubes opposite of each other are of equal weight and

size. Use sample fluid or water to provide balance. Proper sample

balancing will improve sample separation and will extend life of the

centrifuge. Please place test tubes into rotor buckets according to

follow configurations:

Figure 2 - Sample Balancing Diagram

5. Adjust speed in increments of 100rpm.

6. Set desired operation time in increments of 1 minute. Maximum

operation time is 30 minutes.

7. Make sure lid is closed and locked, and press [On] to start operation

8. Timer will count down in increments of 1 minute. When remaining

time is less than 1 minute, the centrifuge will automatically switch

count-down unit to seconds.

9. Centrifuge will decelerate at time '0'. When comes to a complete

stop, centrifuge lid will automatically unlock accompanied by 5

consecutive loud beeps.

Pg | 3

Note: the lid will remain unlock for 3 seconds only. Afterwards, please press

[off] to unlock and open the lid.

5. Maintenance and Care

With proper care and maintenance, S-33 will provide years of service to

your laboratory. Please follow the recommended guidelines:

1. Always disconnect the power source before performing cleaning

and maintenance

2. Use only quality test tubes. Lower quality glass tubes are likely to

fracture, leaking its contents into the rotor buckets even under low

rpm.

3. Never force a test tube into the rotor bucket. The rotor buckets are

designed to hold most commonly sized tubes, vacutainers, and SST's.

Some tubes are too large for the rotor buckets therefore should not

be used in the S-33.

4. Keep rotor buckets clean. If a test tube breaks inside the rotor

bucket, either dispose the entire rotor bucket and its content or

safely dispose the sample and broken glass. Make sure to

thoroughly clean and disinfect the inside and outside of the rotor

buckets.

5. It is recommended that the centrifuge to be cleaned at least once

every week. Any spilled sample in the chamber and on the

centrifuge must be immediately wiped and cleaned. Only use mild

cleaning solutions when cleaning the centrifuge. Strong and acidic

cleaners are not recommended for cleaning and should never be

used on the centrifuge. The rotor and buckets can be autoclaved up

to 120˚C for sterilization. Consult manufacturer before cleaning or

sterilizing the centrifuge with any methods not specified by the

manufacturer.

Pg | 4