- ページ 5

自転車 Ampler Curt 2019-2021のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Ampler Curt 2019-2021 18 ページ。

Attach the pedals

Attach the reflectors

Setup

1. The pedals are marked R (right) and L (left). This refers to the

direction of travel. The R pedal goes on the side of the chain and

the L pedal on the side where the chain is not.

2. First turn the pedals a few turns by hand. If this does not work, it

is possible that you have mixed up the sides or have set it at an

angle.

3. When the first threads are in, insert the hex key through the thread

in the crank arm and hand-tighten the pedals.

Resistance should only be felt at the end of the thread.

If the pedal is difficult to turn from the beginning, check whether you

screwed it in crookedly.

left

right

1. Clamp the white front reflector below the front light.

2. Attach the red rear reflector to the bracket. Wrap the bracket

around the seat post and secure it with the screw.

3. On Curt: Attach two orange reflectors on the front wheel and two

on the rear wheel, in a 180° angle towards each other. To do this,

remove the plastic clasp, Pick a spoke, place the reflector on the

spoke and push the clasp in again. Fasten it with a screwdriver.