- ページ 5
製氷機 Follett HCD710ABTのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Follett HCD710ABT 12 ページ。 To ice storage bin top-mount applications
Follett HCD710ABT にも： クイック・スタート・マニュアル (8 ページ)
ページを印刷する
2.
Site Preparation
Provide drainage, potable water supply and electrical power to within 6 feet (2m) of ice machine
in accordance with local and national codes. Outdoor installation is not recommended and will
void warranty.
2.1
Installation site requirements
208 V –5% to 230 V +5%
Electrical
➊
§ This appliance should be permanently connected by a qualified person in accordance with applicable codes.
§ If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
H_C1010/1410(A/W)BT 208-230/60
Requires a 15A dedicated circuit.
H_E1010/1410(A/W)HS 230/50
(H_E1000A/W requires 15A circuit, 1.50 mm
‡ Plug must be provided by end user & must conform to standard EN 60 335-2-24 of the end destination.
Potable Water Supply
10 psi to 70 psi (69 kpa to 483kpa)
§ This equipment is to be installed with adequate backflow protection to comply with applicable federal, state, and
local codes
Condenser water supply for water-cooled systems
10 psi min.; 150 psi max. (69 kpa min.; 1034 kpa max.)
20 F to 90 F (–7 C to 32 C)
1.5 gallons (5.68 liters) per minute
➍
Drain
(3/4" Barb)
Minimum 8" radius on silicone drain line. The drain line from the ice machine must have at least 1/4 in. per foot
(6,4 mm/0,3 m) pitch
BIN • TOP-MOUNT
‡
wire)
2
➋
(3/8" push-in internal connection, 3/8" OD tubing required)
2 ft. x 1" OD
silicone tubing
3/4" barb x 3/4" FPT
➌
3/4" MPT x 1" slip
➍
1" Stand pipe/Drain
➋
➌
➊
➍
1/4"
1'
WARNING!
HCD/HMD710ABT 115/60
Requires dedicated 15A circuit.
H_E1400(A/W)HS 230/50/1-20 amps
(H_E1400A/W requires 20A circuit, 4.00 mm
45 F to 90 F (7 C to 32 C)
➌
(1/4" FPT inlet, 1/4" FPT outlet)
Horizon 710/1010/1410
Minimum 8"
radius
H_C1010A/W
NEMA
6-15
H_C1410A/W
NEMA
6-20
H_D710A
NEMA
5-15
‡
wire)
2
5