- ページ 16

製氷機 Follett HCE1410WのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Follett HCE1410W 16 ページ。 Ice machines (self-contained) 50 hz and 60 hz

ページを印刷する

Ice machine disposition

Legend:

Ice machine is making ice.

Excessive water in bin or

coming into bin from transport

tube.

8. Ice machine is not making ice.

Lo water.

ATTENTION!

To prevent circuit breaker overload, wait 5 minutes before restarting

this unit. This allows the compressor to equalize and the evaporator

to thaw.

Warranty Registration and Equipment Evaluation

Thank you for purchasing Follett equipment. Our goal is to earn your complete satisfaction by delivering high-value products and

services backed by outstanding customer and technical support.

Please review the installation instructions thoroughly. It is important that the installation be performed to factory specifications so

your equipment operates at its maximum efficiency.

Follett LLC will not be liable for any consequential damages, expenses, connecting or disconnecting charges, or any losses

resulting from a defect of the machine. For full warranty details, visit our website www.follettice.com/productwarranties.

Registering your equipments helps Follett track your equipment's service history should you need to contact us for technical

support, and your feedback helps us improve our products and services. Please visit www.follettice.com/support to complete the

Warranty Registration form.

Should you have any questions, please contact Follett's technical support group at (877) 612-5086 or

(610) 252-7301 and we will be happy to assist you.

Harmony, Ice Manager, Micro Chewblet, SafeCLEAN Plus, SaniSponge and Vision are trademarks of Follett LLC.

Chewblet, RIDE and Follett are registered trademarks of Follett LLC, registered in the US.

Possible causes

OFF

ON or OFF

1. Failed water sensors. Processor

assumes there is no water when

there is water.

2. Blocked reservoir vent.

3. Defective water feed solenoid

valve. Stuck in open position.

1. Water supply is insufficient.

2. Low water pressure.

3. Defective water feed solenoid

valve. Stuck in closed position.

4. No water feed output from

PC board.

5. Plugged screen on inlet side of

fill solenoid.

6. Plugged check valve.

801 Church Lane • Easton, PA 18040, USA

Toll free (877) 612-5086 • +1 (610) 252-7301

www.follettice.com

Corrective action

FLASHING

1. Clean or replace water probe

assembly. Check wiring

connections.

2. Clean or replace vent tubes.

3. Replace water feed solenoid

valve.

1. Restore water supply and check

water filters. If evaporator was

completely empty the reset

button may have to be pressed

to restart the ice machine.

2. Ice machine will eventually start

when water reaches normal lo

level.

3. Replace water feed solenoid

valve.

4. Replace PC board.

5. Remove and clean screen.

6. Remove and clean.

Follett Europe Polska Sp. z o.o.

Mokry Dwór 26 c • 83-021 Wiślina, Poland

+48 (58) 785-6140 • Fax +48 (58) 785-6159

www.folletteurope.com

01266568R00