ページを印刷する
HEAD UNIT
The JP33 & JP43 have 2 (two) Power & Ground inputs
The JP63 & JP83 have 3 (three) Power & Ground inputs
Attach the correct cables and wires accordingly.
+12V POWER
Connect the +12V terminal of the ampli er to the positive terminal of the ba ery using the same diameter
as the ground cable, making sure you install in-line fuse holder, approximately 11 inches to 16 inches
( 300 mm to 400 mm ) from the positive terminal of ba ery, making sure that there is no fuse in the holder
GROUND ( GND )
Disconnect the ba ery and connect the GND (ground) terminal to the car's chassis.
Keep this cable as short as possible (not longer than 20 inches ).
Making sure that the connection with the chassis is rust free and clear of paint or grime.
With high power ampli ers, It is best to connect ground to negative ( ) ba ery terminal.
REMOTE ( REM )
Connect the REM terminal of the ampli er to the power antenna terminal or the dedicated remote
turn on using 12 or 16 ga. electrical wire.
GROUND
THE JP33, JP43, JP63 & JP83 are not supplied with internal fuses.
Make sure you install an in-line fuse holder
from the POSITIVE terminal of ba ery.
BATTERY
Caution