- ページ 11

スイッチ Dahua D-PFS4226-24ET-240のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dahua D-PFS4226-24ET-240 16 ページ。 Poe switch 16/24-port managed desktop switch

Grounding the Device can protect it against lightning and interference.

Step 1

Remove the ground screw from the Device and pass the ground screw through the round

hole of the OT terminal of the ground cable. Turn the ground screw clockwise with a cross

screwdriver to fasten the OT terminal of the ground cable.

Step 2

Wind the other end of the ground cable into a circle with the needle-nose pliers.

Step 3

Connect the other end of the ground cable to the ground bar, then turn the hex nut

clockwise with a wrench to fasten the other end of the ground cable to the ground

terminal.

Before connecting the power cord, make sure that the Device is securely grounded.

Step 1

Connect one end of the power cord to the power jack of the Device.

Step 2

Connect the other end of the power cord to the external power socket.

The Ethernet port is a standard RJ-45 port. With its self-adaptation function, it can be automatically

configured to full duplex/half-duplex operation mode. It supports MDI/MDI-X self-recognition of the

cable, , allowing you to use a cross-over cable or straight-through cable to connect the terminal

device to the network device.

The cable connection of RJ-45 connector conforms to the 568B standard (1-orange white, 2-orange,

3-green white, 4-blue, 5-blue white, 6-green, 7-brown white, 8-brown).

4 Wiring

Figure 4-1 Connect GND

Figure 4-2 Ethernet port pin number